Rockwell-automation AutoMax ControlNet Communication Interface Module Manual de usuario descargar pdf (Pagina 53)

AutoMax ControlNet Module Page 53

Publication number DSMBCN-UM001B-EN-P February 2003

Extended Status (EXT_STS) Codes for Command 0F

If the value in the upper byte of the GATEWAY_CMD_OK@ "status"

parameter variable is 3F, then there is a value in the upper byte of the

extended status register (register 33 on the module) that supplies further

information.

The following table shows possible values for the extended status error

code.

Code, hex Description

0 (not used)

1 A field has an illegal value

2 Less levels specified in address than minimum

for any address

3 More levels specified than system supports

4 Symbol not found

5 Symbol is of improper format

6 Address doesn't point to something usable

7 File is wrong size

8 Cannot complete request; situation has

changed since the start of the command

9 Data or file is too large

A Transaction size plus word address is too large

B Access denied, improper privilege

C Condition cannot be generated; resource is not

available

D Condition already exists; resource is already

available

E Command cannot be executed

F Histogram overflow

10 No access

11 Illegal data type

12 Invalid parameter or invalid data

13 Address reference exists to deleted area

14 Command execution failure for unknown

reason; possible PLC-3 histogram overflow

15 Data conversion error

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 79 80

Sin comentarios

Rockwell-automation AutoMax ControlNet Communication Interface Module Manual de usuario Pagina 53