Rockwell-automation AutoMax ControlNet Communication Interface Module Manual de usuario descargar pdf (Pagina 52)

Page 52 AutoMax ControlNet Module

Publication number DSMBCN-UM001B-EN-P February 2003

Code, hex Description

11 Destination memory full, cannot accept

command now

12 Destination did not acknowledge command

13 Network contention, possible duplicate node or

bad cabling

14 Local port is disconnected, or no other node

found

15 Timeout waiting for a reply message

16 Duplicate node detected

17 Node is offline

18 Hardware fault

1D Transaction number mismatch

1E Duplicate transaction number

31 Illegal command or format

32 Host is malfunctioning and will not

communicate

33 Remote node host is missing, disconnected, or

shut down

34 Host could not complete function due to

hardware fault

35 Addressing problem or memory protected

rungs

36 Function disallowed due to command

protection selection

37 A-B Processor is in program mode

38 Compatibility mode file missing or

communication zone problem

39 Remote node cannot buffer command

3A (not used)

3B Remote node problem due to download

3C Cannot execute command due to active IPBs

3D (not used)

3E (not used)

3F There is an error code in the Extended Status

section 0.

Figure 13 Local and Remote Status Table

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 79 80

Sin comentarios

Rockwell-automation AutoMax ControlNet Communication Interface Module Manual de usuario Pagina 52