Rockwell-automation 20-COMM-I Interbus Adapter Manual de usuario descargar pdf (Pagina 33)

Chapter

Configuring the Interbus Scanner

Interbus scanners are available from several manufacturers, including

SST. Chapter 4 provides instructions on how to utilize Phoenix Contact

CMD software to configure the network on an SST scanner.

All examples in this manual are based on the following:

• SLC controller with a SST Interbus scanner (SST-IBS-SLC)

in slot 1.

• PowerFlex 70 at Device 1.0 / CR 2 (CR# is needed for PCP

commands).

• Power Flex 70 at Device 2.0 / CR 3 (CR# is needed for PCP

commands).

• Logic Command / Status, Reference / Feedback and Datalinks A-D

are enabled in the 20-COMM-I and mapped to network I/O.

• Phoenix Contact CMD software is used to configure the network.

This chapter describes the steps to configure a simple network like what

is featured in Figure 4.1

Topi c Pag e

Example Network

4-1

Using CMD Software to Configure the Network 4-4

Adapter Configuration Settings to use with Ladder Examples 4-3

PowerFlex 70 Settings to use with Ladder Examples 4-15

RSLogix 500 SST Interbus Scanner Configuration 4-15

Example Network

20COMM-UM007A-EN-P.book Page 1 Tuesday, January 22, 2002 10:52 AM

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 117 118

Sin comentarios

Rockwell-automation 20-COMM-I Interbus Adapter Manual de usuario Pagina 33