Rockwell-automation 57C620 AutoMax Programming Executive Version 3.8 Manual de usuario descargar pdf (Pagina 107)

6Ć9Configuring Racks

6.3 Adding a Foreign Module or Other

Unsupported Module

Any

foreign module, i.e., nonĆAutoMax or DC

S 5000, must meet strict

requirements before it can be used in an AutoMax rack and

configured for the rack. See Appendix H for these requirements

before attempting to add a foreign module to the rack.

Foreign

modules and AutoMax modules that are not supported in this

version of the Programming Executive software can be added to the

rack as generic" I/O modules. The generic module should also be

used if a

currently existing module is enhanced and the existing form

does not allow you to configure the view or changed registers. Three

generic modules are available, one with 32 registers (GEN32), one

with 32,768 registers (GEN32K), and one with 8000H registers in hex

(GEN32KH). GEN32K and GEN32KH are available only in the local

rack. GEN32 is available in a local rack and in a remote rack.

6.4 Configuring Drive Parameters

The Configure Parameters command on the Configure menu is used

to configure drive parameters. This command can be selected only

after you have added a Universal Drive Controller (UDC) module to

the rack. The UDC Parameter Entry screens can be accessed in two

ways. From the main Rack Configurator screen, select the UDC

module and then select Configure Parameters from the Configure

menu.

rom the P

ower Module Interface display screen (accessed by

zooming into the UDC module), select Configure Parameters from

the Configure menu. Refer to the DC Drive Configuration and

Programming

instruction manual (S

Ć3006) for detailed descriptions of

how to configure the drive parameters.

6.5 Modifying Module Information

The following procedure enables you to modify information for the

module in the selected slot. See the section below if you want to

modify UDC module information. The Modify procedure does not

allow you to remove the module from the rack; it only allows you to

modify information in the database about the module in the selected

slot.

Note

carefully that any variables already defined for the

module in the

Variable Configurator described in section 7 will remain unchanged.

Step 1. Select the slot containing the module for which you want

to modify information.

Step 2. Select Modify from the Configure menu. A Card Info

dialog box will display the information for the requested

module.

Step 3. Modify the desired fields. Any field that is not dimmed can

be changed.

Step 4. Select OK to accept changes or Cancel to return to the

Rack

Configurator

window without executing the changes.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 297 298

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 57C620 AutoMax Programming Executive Version 3.8 Manual de usuario Pagina 107

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 57C620 AutoMax Programming Executive Version 3.8