Rockwell-automation 57C620 AutoMax Programming Executive Version 3.8 Manual de usuario descargar pdf (Pagina 196)

18Ć8 AutoMax Programming Executive Version 3.x

ON LINE direct C: \LIB\SYS\RACK

EscăExit

Monitor Variable Modify

#Task Variable

Low Limit

Value

Hi Limit

Set Tune Force Unforce

Figure 18.4 Ć Monitor V

ariable Modify Menu

18.1.6.1 Ć 18.1.6.4 below describe the options available from the

Monitor Variable Modify menu in more detail.

18.1.6.1 Setting a Variable to a Specific Value

You can set variables to specific values using S" for Set from the

Monitor Variable Modify menu. The variable you want to set does

not need to be in the screen display for you to set it. Note that a

variable that has been set may later be affected by an active

application task. Follow the directions below to set a variable:

1. Display the variable on the screen following the directions in

18.1.1

above to verify the present value of the variable (optional).

Enter S" for Set from the

Monitor Variable Modify menu.

3. If the variable you want to set is not displayed on the screen,

enter the name of the task where the variable is defined at the

blinking cursor, followed by Enter" or <CR>. Continue at step

If the name of the variable you want to set is displayed on the

screen, you can enter the number of the line (1Ć16) on which the

variable name appears, followed by Enter" or <CR>. The

screen will display the task name in the Task" field and the

variable name in the Var" field. Skip to Step 5.

4. Enter the name of the variable to be set, specifying variable type

with the correct terminator at the blinking cursor, followed by

Enter" or <CR>.

The V

alue" field will display the last value that was set for a

variable. If this is the first time you are setting this variable, the

field will be blank. Enter the desired value for the variable, typing

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 297 298

Sin comentarios

Rockwell-automation 57C620 AutoMax Programming Executive Version 3.8 Manual de usuario Pagina 196