Rockwell-automation 57C620 AutoMax Programming Executive Version 3.8 Manual de usuario descargar pdf (Pagina 162)

11Ć4 AutoMax Programming Executive Version 3.x

Field C" will show a C if the task has been designated as CRITICAL

in the configuration for the rack. CRITICAL tasks are those that

cannot be stopped individually, i.e., all tasks must be stopped in

order for the task in question to be stopped.

An M in field M" indicates that the task has been modified, but has

not been saved from the Processor module. This field is used only

when tuneables have been changed either by the operator, or for

UDC

tasks, by the PMI operating system, or when Ladder Logic tasks

have been modified. For more information about saving tasks from

the Processor module, see section 14.4.

Field 

A" will show a U" if the user has task access, or O" if another

user has task access to the task. For single user (nonĆnetwork)

applications, this field will be blank or will display U" if the user has

edited the task.

Finally, Status" shows whether each task loaded in the rack is

currently running (RUN) or stopped (STOP), and whether there has

been an error (ERROR) in each task.

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 297 298

Sin comentarios

Rockwell-automation 57C620 AutoMax Programming Executive Version 3.8 Manual de usuario Pagina 162