Rockwell-automation 57C620 AutoMax Programming Executive Version 3.8 Manual de usuario descargar pdf (Pagina 261)

KĆ1

Appendix K

Import Notes

The procedure for importing racks and tasks from AutoMax Executive V1 or V2 is

described

in detail in section 5.3.9. This appendix describes some anomalies

that

may occur in the import procedure. See Appendix Q for information about

importing racks and task from earlier V3 Executives.

For some modules, registers defined in AutoMax V2 cannot be configured in the

current Executive software. Before you import a system or rack, first check (and

edit, if necessary) your AutoMax V2 configuration task. Otherwise, an error

message may be displayed (invalid/incompatible data type) when you try to

configure the module. See the examples that follow.

Resolver Input Module (M/N 57C411) Example

Registers 2 and 3 of the Resolver Input module are illustrated below:

R R R R R R R R R R

- - -

R R R

0123456789101112131415

R R

R R R R

RW RW - - - RW RW RW

bits

Interrupt line ID

ăăă Interrupt allocated

ăăăăInterrupt clock enable

ăăăăInterrupt enabled

Module fault

ăResolver not connectedă

ăăăăăCommon clock off

Isolated power fault

External strobe reset

Position angle increasing

External strobe status

Interrupt flag status

Registers 2 and 3 each define the same variables. Register 2 is read only ,"R,"

and contains only R" bits. Register 3 is read/write, R/W," and it contains both

R/W" and R" bits. The current version of the Executive software allows data to

be read only from an R" register. Therefore, all of the above variables can be

read from register 2 only. Data can be written to register 3 only.

Before executing the Import procedure, examine your AutoMax V2 configuration

task to see how you are using registers 2 and 3. Make any necessary changes to

ensure that you are reading from register 2 only and writing to register 3.

1 2 ... 256 257 258 259 260 261 262 263 264 265 266 ... 297 298

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 57C620 AutoMax Programming Executive Version 3.8 Manual de usuario Pagina 261

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 57C620 AutoMax Programming Executive Version 3.8