Rockwell-automation 1738-AENTR, Series B POINT I/O and ArmorPOINT I/O Manual de usuario descargar pdf (Pagina 27)

Rockwell Automation Publication 1734-UM017B-EN-E - October 2013 19

Chapter

Configure the Adapter with RSLogix5000

software

Introduction

This chapter guides you through the steps required to configure your modules

using the RSLogix

5000 software. Note that the modules presented in this

chapter can be configured using RSLogix 5000 software, version 17, or later.

Before using your adapter in an EtherNet/IP network, you need to configure it

with an IP address, subnet mask, and optional Gateway address. This chapter

describes these configuration requirements and the procedures for providing

them. Here are ways you can do this:

• Use the Rockwell BootP/DHCP utility, version 2.3 or later, that ships

with RSLogix 5000 or RSLinx software.

– You can also use this utility to reconfigure a device with an IP address

you must change.

• Use a

third party DHCP server.

• Use the Network Address thumbwheel switches.

• Have your network administrator configure the adapter via the network

DHCP server.

See the table for where to find information in this chapter.

Adding POINT and ArmorPOINT modules through RSLogix 5000 involves

the same general procedures. Note, however, that the two modules do not have

exactly similar Module Definition properties or configuration parameters. The

customization of both modules are distinctly covered in the next sections.

Topic Page

Configuration Requirements

IP Address 20

Gateway Address 21

Subnet Mask 22

Set the Network Address 23

Set the Network Address for POINT I/O Adapters 23

Set the Network Address for ArmorPOINT I/O Adapters 24

Use the Rockwell BootP/DHCP Utility 24

Save the Relation List 27

Use DHCP Software to Configure Your Adapter 28

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 119 120

Sin comentarios

Rockwell-automation 1738-AENTR, Series B POINT I/O and ArmorPOINT I/O Manual de usuario Pagina 27