Rockwell-automation 1738-AENTR, Series B POINT I/O and ArmorPOINT I/O Manual de usuario descargar pdf (Pagina 46)

38 Rockwell Automation Publication 1734-UM017B-EN-P - October 2013

Chapter 4 Configure the Adapter for Direct Connection in RSLogix 5000 Software

6. Choose values for Series, Revision, Electronic Keying, Connection, and

Chassis Size, noting that we used the following values:

Connection choices are the following:

• None – the adapter only makes a direct connection to each of the

modules referenced by the data. RSI is disabled in this case.

• Rack optimization – digital I/O data is collected into a rack image. This

rack image does not include analog or specialty I/O modules.

• Listen only - rack optimization – read or verify input data only, but does

not control the modules. When you have multiple controllers, one

controller is used to control and the other controllers are used to

monitor. When the owning controller of rack-optimized connection

closes the connection, the Listen-Only data will also stop.

7. Choose None as Connection, because we are only making direct

connections, then click OK.

Note: There is no need to have a rack-optimized connection if all I/O

connections to the POINT I/O modules are directly connected.

A dialog box opens.

8. Click Yes.

Series B

Connection None

Chassis Size 5

Electronic Keying Compatible Module

Revision 4.3

IMPORTANT

The chassis size value equals 1 for the adapter plus the number of I/O

modules installed (physically present on the I/O backplane).

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 119 120

Sin comentarios

Rockwell-automation 1738-AENTR, Series B POINT I/O and ArmorPOINT I/O Manual de usuario Pagina 46