Rockwell-automation 20G PowerFlex 755 Drive Embedded EtherNet/IP Adapt Manual de usuario descargar pdf (Pagina 26)

26 Rockwell Automation Publication 750COM-UM001E-EN-P - October 2013

Chapter 3 Configuring the Adapter

Using the PowerFlex 20-HIM-

A6 or 20-HIM-C6S HIM to

Access Parameters

If your drive has an enhanced PowerFlex 20-HIM-A6 or 20-HIM-C6S HIM, it

can be used to access parameters in the adapter.

1. Display the Status screen, which is shown on HIM powerup.

2. Use the or key to scroll to the Port in which the embedded

EtherNet/IP adapter resides (always Port 13).

3. Press the PAR# soft key to display the Jump to Param # entry pop-up box.

4. Use the numeric keys to enter the desired parameter number, or use the 

or  soft key to scroll to the desired parameter number.

For details on viewing and editing parameters, see the PowerFlex 20-HIM-A6/-

C6S HIM (Human Interface Module) User Manual, publication 20HIM-

UM001.

Setting the Adapter IP

Address

When the adapter IP Address switches (Figure 1 on page 19) are set to a value

other than 001…254 or 888, Parameter 36 - [BOOTP] determines the source

for the adapter node address. By default, the embedded EtherNet/IP adapter is

configured to set its IP address, subnet mask, and gateway address by using a

BOOTP server. To use a BOOTP server to set the node address, see the

procedure in Using a BOOTP Server

. To use adapter parameters, see Using

Adapter Parameters on page 30.

Using a BOOTP Server

There is a variety of BOOTP servers available. The following instructions use

Rockwell Automation’s BOOTP/DHCP Server, version 2.3 or later, a free

standalone program that incorporates the functionality of standard BOOTP and

DHCP utilities with a graphical interface. It is available from http://

www.software.rockwell.com/support/download/detail.cfm?ID=3390. See the

Readme file and online Help for directions and more information.

TIP

If the PowerFlex 755 drive is connected to a Stratix 6000 or Stratix 8000

managed Ethernet switch and the drive is set for BOOTP mode, the ‘dynamic IP

address assignment by port’ (Stratix 6000) or ‘DHCP persistence’ (Stratix 8000)

feature will set the IP address for the drive. For more details, see the Stratix

6000 Ethernet Managed Switch User Manual, publication 1783-UM001

, or the

Stratix 8000 and Stratix 8300 Ethernet Managed Switches User Manual,

publication 1783-UM003

TIP

If you prefer to configure the IP address, subnet mask, and gateway address

using adapter parameters, set adapter Parameter 36 - [BOOTP] to ‘0’

(disabled). For details, see Using Adapter Parameters

on page 30.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 189 190

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 20G PowerFlex 755 Drive Embedded EtherNet/IP Adapt Manual de usuario Pagina 26

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 20G PowerFlex 755 Drive Embedded EtherNet/IP Adapt