Rockwell-automation AADvance Controller Configuration Guide Manual de usuario Pagina 159

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 286
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 158
Document: 553633
ICSTT-RM405f-EN-P
Issue 07
6-5
Configure the IP Address of the Target Controller
To connect the AADvance Workbench project to the target controller you have to
tell the project the IP addresses allocated to the controller. Do the following:
1) Select the Hardware Architecture view then double-click on the vertical
connection between the SNCP network line and the configuration.
2) The Connection - Properties dialog box opens.
3) Enter the IP Addresses in the Value field for each of the required Ethernet
network. Press Enter after typing each IP address.
Note: The value shown above is a default value. Enter a value that you require.
4) Click OK.
Vista de pagina 158
1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 285 286

Comentarios a estos manuales

Sin comentarios