Rockwell-automation AADvance Controller Configuration Guide Manual de usuario Pagina 236

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 286
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 235
10-2
Document: 553633
ICSTT-RM405f-EN-P
Issue 07
Configuration Guide (AADvance Controller)
SNCP Networks
You can set up a single SNCP network to communicate with the target. When two
controllers are set up with their IP Addresses on the same subnet, they also appear on
the same physical network. This single logical network can also be used to configure
variable bindings over redundant physical networks.
Setting Up Single Networks
When you create a project it has a default single network configuration.
1) Create a project.
This configuration represents a single logical network.
The configured IP address is the IP address used by the Workbench to
communicate with the target.
Vista de pagina 235
1 2 ... 231 232 233 234 235 236 237 238 239 240 241 ... 285 286

Comentarios a estos manuales

Sin comentarios