Rockwell-automation 1440-DYN02-01RJ XM Dynamic Measurement Module Manual de usuario descargar pdf (Pagina 51)

Publication ICM-UM002F-EN-E - March 2013 51

Installing the XM Dynamic Measurement Module Chapter 2

The module is shipped from the factory with the node address set to 63 (as

shown below).

Follow the steps below to set the node address.

1. Refer to XM Bus Node Address table on page 52

for the switch settings

of a specific address.

2. Using a pointed tool, slide switches 5 through 10 to the appropriate

positions (1 or 0).

DYNAMIC MEASUREMENT

1440-DYN02-01RJ

Switch 1...4 are not used

Switch 5...10 Node Address setting

TIP

The node addresses start with 1 for the module closest to the

ACNR, and increase for each consecutive module.

EXAMPLE

If you want the node address to be 4 then you would set dip

switches 5...8 as follows.

Up position = 1

Down position = 0

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 159 160

Sin comentarios

Rockwell-automation 1440-DYN02-01RJ XM Dynamic Measurement Module Manual de usuario Pagina 51