Rockwell-automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardP Manual de usuario descargar pdf (Pagina 33)

Publication 1753-PM001A-EN-P - November 2005

Connect to the GuardPLC Controller 1-23

Change the IP Address of

the Controller

After you establish communications with the controller, you can

change the IP address of the controller to match your Ethernet

network. There are two ways to change the IP address of the

controller:

From the Control Panel:

1. Choose Device Settings from the Extra menu.

2. Enter the new IP address.

3. Click OK.

Or follow Step 4: Get Communication Settings on page 1-9 and

Step 5: Change Settings via MAC Address on page 1-10.

TIP

Typically, you change the SRS of the GuardPLC

controller to match that of the controller/routine that

you wish to download to it. Recall that the SRS is

compiled into the executable and ensures that this

.EXE can only be downloaded to a GuardPLC

controller with a matching SRS.

TIP

To re-establish communications with the new IP

address and subnet of your GuardPLC controller, you

may need to change the IP and subnet address of

your programming terminal. Use the Network

section of the Windows Control Panel to change the

programming terminal’s IP address and subnet mask.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 121 122

Sin comentarios

Rockwell-automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardP Manual de usuario Pagina 33