Rockwell-automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardP Manual de usuario descargar pdf (Pagina 57)

Publication 1753-PM001A-EN-P - November 2005

Create a GuardPLC Project 3-17

2. Click OK

Compile the Code

1. Close the Type Instance Program.

2. Right-click Resource and choose Code Generation.

3. The results of the code generation are shown on the Error State

Viewer.

If the Error State Viewer is not visible, click the red triangle

to make it visible.

If the compile was successful, ‘Error Free code generated’ appears in

the Error-State Viewer.

TIP

The FB editor menu bar displays the number of

edits since the last save. Following a save, it

displays ‘(unchanged)’.

TIP

If you are using a GuardPLC 1800 controller, you will

see a warning in the Error State Viewer. Go to the

Hardware Management window to view the

warning, which reads ‘USED’ has an initial value, but

no source.’ Disregard this warning, because the

‘USED’ signal has an initial value of 1, but no source

drives its value.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 121 122

Sin comentarios

Rockwell-automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardP Manual de usuario Pagina 57