Rockwell-automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardP Manual de usuario descargar pdf (Pagina 35)

1 Publication 1753-PM001A-EN-P - November 2005

Chapter

Connect to GuardPLC Distributed I/O Modules

In This Chapter

This chapter guides you through the process of addressing,

configuring, and connecting to the distributed I/O modules. GuardPLC

distributed I/O modules are ‘owned’ by a GuardPLC controller. This

allows the parent controller to connect signals to the inputs and

outputs of the distributed I/O modules the same way that signals are

connected to the controller’s local I/O.

Understand Module

Addressing

Module Default Settings

The out-of-box settings for a GuardPLC distributed I/O module are

shown in the table below.

SRS (System.Rack.Slot)

The SRS of the parent controller is always xxxxx.0. For example, the

default SRS of a GuardPLC controller is 60000.0. If you change the SRS

to 25, the actual SRS of the controller is 25.0.

For this information See page

Understand Module Addressing 2-1

Add the Module to the Hardware Configuration 2-2

Configure the Module 2-3

Go Online With the Module 2-5

Parameter Setting

IP Address 192.168.0.99

Subnet Mask 255.255.252.0

SRS

(1)

(1) The SRS code is compiled with the program.

60000.1

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 121 122

Sin comentarios

Rockwell-automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardP Manual de usuario Pagina 35