
Message Packet Formats
Chapter 5
5-24
Enable Scan
This command restarts the PLC processor’s program scanner after a
physical write operation has been performed. Note that you must always
use the enable scan command to restart the PLC processor after a physical
write command.
Command
Format:
Reply Format:
TNSSTSCMD
07
SRCDST
TNSSTSCMD
47
SRCDST
FNC
03
Physical Read
This command reads bytes of data from the PC data table or program
memory. Use this command to upload the contents of PLC memory to
your computer.
Use the SIZE field to specify the number of bytes to be read. To specify a
number of PC words, SIZE should be an even value because PC words are
two bytes long.
Command
Format:
Reply Format:
TNSSTSCMD
04
SRCDST
TNSSTSCMD
44
SRCDST
ADDR
DATA
— Max. of 244 Bytes
SIZE
Comentarios a estos manuales