
Error Reporting
Chapter 7
712
Code (If Applies)
EXT STS
STS
Meaning
Error
Code
194
Expression is too complex.
199
Attempt to divide by zero.
200
Bad port specifier
. That is, the character following the #" is other
than H", h", M", or m".
201
User symbol used as part of remote address specification.
202
Undefined data following assignment command. This error would
occur
, for instance, if the modifier UNRPOT were used instead of
UNPROT.
203
Error in remote specification.
1.
A character other than @" or $" following the station
number specification (... = #H045*T
...).
2.
Something other than EOL, PROT
, or UNPROT following a
remote source add. (.... = #H012$S5:8 + 9).
204
Thirdparty transfer
. That is, in an assignment command, both
the source and the destination were remote addresses.
205
Error in evaluating a PLC2 address, or PLC2 address greater
than 65,535 bytes.
206
Zero range specified in an assignment command.
207 W
ord range specified in destination address.
208
Destination and source addresses disagree in type.
209
Not of Data Highway message type.
210
Use of a nonPLC3 type address in a local address operand.
211
In an assignment command, one of the local files does not exist,
or the word specified is beyond the end of the file.
213
A local file exists, but the action specified refers to addresses
beyond the end of the file. Possible causes include:
1.
In a word assignment statement, the offset is greater than
the file size.
2.
In a word range assignment statement, the sum of the base
address and the offset is greater than the total file size.
3.
In a file assignment statement, the destination file is smaller
than the source file. If the source file is remote, a single
packet will be fetched from the remote station'
s file.
214
Local source and destination files dif
fer in size.
Comentarios a estos manuales