Rockwell-automation 2098 CompactLogix Indexing Motion Accelerator Tool Manual de usuario descargar pdf (Pagina 72)

72 Publication IASIMP-QS011B-EN-P — January 2009

Chapter 6 Motion FactoryTalk View Integration

Adding Axes to the Project

The CIMME_U3k_PVPxxxx_v00x.apa file has two pre-configured axes for use. In this section you

will add additional axes to your Ultra3000 drive system and the project file.

All the displays in the project file are parameterized to facilitate quick editing and reuse

throughout the application. The following Axis Status display contains faults and status

information that is common to all configured axes (Axis1…Axisx).

Axis Status Display

Add the Parameter File

Follow these steps to add a parameter file to your FactoryTalk View ME application.

1. Expand the FactoryTalk View ME Explorer window to gain access to

Parameters.

The parameters list contains the pre-configured axes within the

application. Each parameter file is associated with a specific axis. When

opening the Axis Status display, the tag information loads from the axis

currently selected.

IMPORTANT

If you have selected a pre-configured application with a specific axis count and it fits your

application needs, skip this section and go to Modifying Axis Names beginning on page 77.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 135 136

Sin comentarios

Rockwell-automation 2098 CompactLogix Indexing Motion Accelerator Tool Manual de usuario Pagina 72