Rockwell-automation 2098 CompactLogix Indexing Motion Accelerator Tool Manual de usuario descargar pdf (Pagina 85)

Publication IASIMP-QS011B-EN-P — January 2009 85

Chapter

Motion System Application Guide

In this chapter, you are guided through the pre-configured FactoryTalk View ME application that

interfaces with the pre-configured Logix program that controls your base motion system. You will

run your motion system in Manual mode and Auto mode, and use the built-in axis status and

diagnostics.

Before You Begin

• Complete your system hardware selection. (Refer to Chapter 2.)

• Complete your system layout. (Refer to Chapter 3.)

• Complete your system wiring. (Refer to Chapter 4.)

• Complete your Logix Integration procedures (refer to Chapter 5) and download the Logix

program to your controller.

• Complete your FactoryTalk View ME Integration procedures (refer to Chapter 6) and

download the FactoryTalk View program to your HMI.

What You Need

• Kinetix Accelerator Toolkit CD, publication IASIMP-SP004. For a copy of the CD, contact your

local Rockwell Automation distributor or sales representative.

• Hardware installation and wiring complete, with power applied.

• Logix application file (CIMLxx_xaxis_v00x.acd) downloaded to CompactLogix controller.

Controller is set to run.

• FactoryTalk View ME runtime application file (IMME_PVPxxxx_v00x.mer) downloaded to the

PanelView Plus terminal. Run Application activated on terminal.

• Ultra3000 Digital Servo Drive Installation Manual, publication 2098-IN003.

ATTENTION

To reduce the possibility of unpredictable motor response, disconnect all loads from your motors

until initial axis tuning is complete. For tuning procedure, refer to the Ultra3000 Digital Servo Drive

Installation Manual, publication 2098-IN003.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 135 136

Sin comentarios

Rockwell-automation 2098 CompactLogix Indexing Motion Accelerator Tool Manual de usuario Pagina 85