Rockwell-automation 2098 CompactLogix Indexing Motion Accelerator Tool Manual de usuario descargar pdf (Pagina 92)

92 Publication IASIMP-QS011B-EN-P — January 2009

Chapter 7 Motion System Application Guide

Use the Axis Status Display

The Axis Status display shows general motion, axis, and drive status, and faults.

Follow these steps to view status and fault indicators and to select the axis.

1. Press Status on the Application Navigation Bar. The Axis Status display opens.

2. Select a system Status or Fault

category from the axis (left)

window.

The green indicator confirms your

status/faults selection.

3. Monitor the status or fault

indicators (right side and below.)

In this example, Axis Status

indicators are shown. Servo

Enabled, Servo Faulted, and

Network Fault status indicators are

always present.

Axis Status, Drive Status, Axis Faults, and Drive Faults indicators show the corresponding

status/faults of the axis displayed on the Axis Select button.

The ON/OFF and Faulted/Non-Faulted states are described in the tables below.

4. Press Axis Select Axis (1) to select another axis for status and fault viewing. (Refer to Change

the Axis Selection on page 88 for axis selection operation.)

Status Indicators ON State OFF State Fault Indicators

Faulted

State

Non-faulted

State

Axis Status

Green Grey

Module Faults

Red Grey

Drive Status Drive Faults

Status Indicators

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 135 136

Sin comentarios

Rockwell-automation 2098 CompactLogix Indexing Motion Accelerator Tool Manual de usuario Pagina 92