Rockwell-automation 2098-IPD-xxx Ultra5000 C Programming using the Mot Manual de usuario descargar pdf (Pagina 46)

Publication 2098-PM001E-EN-P — July 2002

2-6 Referencing the Motion Library

float AxisGetVelError(void);

Returns the velocity error in counts/second.

Note: Velocity error is calculated by subtracting the value of feedback

velocity from the command velocity.

long AxisSetFeedbackOffset(long offset);

Sets the feedback offset of the axis. Offset is programmed in counts.

Returns 0 if successful, or -1 on an error.

long AxisSetFGain(float fgain);

Sets the acceleration feedforward gain.

Returns 0 if successful, or -1 on an error.

long AxisSetIGain(float igain);

Sets the integral gain of the velocity loop in units of 1/second.

Returns 0 if successful, or -1 on an error.

long AxisSetKff(float kff);

Sets the velocity feedforward gain of the position loop.

Returns 0 if successful, or -1 on an error.

long AxisSetKp(float kp);

Sets the proportional gain of the position loop in units of 1/second.

Returns 0 if successful, or -1 on an error.

long AxisSetLowerCurLimit(float limit);

Sets the lower current limit in Amps.

Returns 0 if successful, or -1 on an error.

long AxisSetPGain(float pgain);

Sets the proportional gain of the velocity loop in units of 1/second.

Returns 0 if successful, or -1 on an error.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 113 114

Comentarios a estos manuales

Sin comentarios