Rockwell-automation 1760-xxxx Pico GFX-70 Controllers User Manual Manual de usuario descargar pdf (Pagina 348)

Publication 1760-UM002B-EN-P - March 2005

7-20 Pico GFX-70 Settings

Activating an Automatic Startup in TERMINAL MODE

Requirement: The GFX is in RUN or STOP mode without visualization (the

System menu must be reachable).

1. Select

TERMINAL MODE in the System menu and press OK.

2. The next time that the GFX is started, it will establish the connection to

the selected device.

3. Press ESC to return to the Status display.

Deactivating an Automatic Startup in TERMINAL MODE

1. Select TERMINAL MODE ✓.

2. Press OK.

The automatic starting in TERMINAL MODE has been deactivated.

The default setting of the GFX is for the display of the TERMINAL MODE

menu, i.e. GFX starts in RUN or STOP mode when the power is switched on.

Setting LCD Contrast and

Backlight

The backlight of the LCD display can be set to one of five stages to adapt it to

local conditions. The display contrast can be set to one of five stages.

The contrast and backlight settings are implemented as device settings.

1. Switch to the System menu.

P BUTTONS ▲

RUN MODE

CARD MODE

TERMINAL MODE ✓ ▼

IMPORTANT

The correct station number must be selected in order for

the GFX to start TERMINAL MODE with the correct

station. (see Commissioning on page 3-1)

P BUTTONS ▲

RUN MODE

CARD MODE

TERMINAL MODE ▼

IMPORTANT

If GFX is protected by a password, the System menu

will not be available until Pico GFX-70 is “unlocked”

(see Unlocking Pico GFX-70 on 7-5).

1 2 ... 343 344 345 346 347 348 349 350 351 352 353 ... 399 400

Comentarios a estos manuales

Sin comentarios