Rockwell-automation LDAT Integrated Linear Thrusters Manual de usuario descargar pdf (Pagina 67)

LDAT-Series Integrated Linear Thrusters 67

Rockwell Automation Publication LDAT-IN001A-EN-P - August 2012

Remove Strip Cover

Refer to this figure when removing the strip cover.

1. Remove the M3 x 0.5 x 6 mm flat-head cap screws and the stator cover.

2. Remove the M3 x 0.5 x 6 mm button-head cap screws and the end clamps.

3. Carefully slide the slider cover from the assembly.

4. If you are removing the strip cover to lubricate the linear thruster, you are finished.

5. If you are replacing the strip cover, do the following.

Peel off the low-friction tape from the stator body and the stator cove and discard.

Item Description Item Description

1Stator cover 4End clamp

2 Stator cover low friction tape 5 Slider cover

3 Stator body low friction tape

ATTENTION: The slider cover has sharp edges. Use care when handling.

Top View of

LDAT-Series Integrated Linear Thruster

(LDAT-S73010xx is shown)

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 79 80

Sin comentarios

Rockwell-automation LDAT Integrated Linear Thrusters Manual de usuario Pagina 67