Rockwell-automation 22-COMM-E EtherNet/IP Adapter Manual de usuario descargar pdf (Pagina 101)

Viewing the Adapter’s Web Pages 9-9

2. Click the desired Adapter Faults check boxes you want to occur that

will send e-mail notification.

3. Type the following information in their respective boxes:

4. Click Save changes.

Important: It is recommended that Parameter 30 - [Web

Features] E-mail Cfg Bit 0 value be set to “0”

(Disabled) after E-mail Notification has been

configured. Otherwise the configuration can be changed

anytime the web page is accessed with a browser.

An example of an e-mail message automatically sent by the adapter in

response to selected events is shown below.

Figure 9.6 Example of E-mail Message Sent by Adapter

Information Description

“IP address of …" Type in the address of the mail server that will be

used to deliver the e-mail messages.

“E-mail addresses to notify …" Type in addresses to where you want e-mail

messages to be sent. Multiple addresses can be

used, but they must be separated by commas

(comma delimited).

“Subject of e-mail message …" Type in the desired subject text for the e-mail

message.

TIP: To stop e-mail messages, do one of the following:

• Delete all e-mail addresses from the Configure E-mail

Notification web page.

• Uncheck all of the “Send an e-mail message when …” boxes.

Disabling the adapter web pages by setting the Web Pages Switch

(SW2 in Figure 2.1

) to the “Disable Web” position will NOT stop

the adapter from sending e-mail messages.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 165 166

Sin comentarios

Rockwell-automation 22-COMM-E EtherNet/IP Adapter Manual de usuario Pagina 101