Rockwell-automation 22-COMM-E EtherNet/IP Adapter Manual de usuario descargar pdf (Pagina 27)

Configuring the Adapter 3-3

By default, the adapter is configured so that you can set its IP address,

subnet mask, and gateway address by using a BOOTP utility. You can

select from a variety of BOOTP utilities. These instructions use

Rockwell’s BOOTP Server (version 2.1), a stand-alone program that

incorporates the functionality of standard BOOTP utilities with a graphical

interface. It is available from http://www.ab.com/networks. Refer to the

Readme file and online Help for detailed directions and information.

To configure the adapter using BOOTP Server

1. On the label of the adapter, locate and note the hardware address of

the adapter.

2. On a computer connected to the EtherNet/IP network, start the

BOOTP software. The BOOTP Server window appears (Figure 3.1

Devices on the network issuing BOOTP requests appear in the

BOOTP Request History list.

Figure 3.1 BOOTP Server Window

3. In the BOOTP Request History list, double-click the hardware

address (Ethernet MAC address) of the adapter. The New Entry

dialog box appears (Figure 3.2

Using BOOTP

TIP: If desired, you can disable BOOTP and configure the IP address,

subnet mask, and gateway address by setting parameters. For details,

refer to Setting the IP Address, Subnet Mask, and Gateway Address in

this chapter.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 165 166

Sin comentarios

Rockwell-automation 22-COMM-E EtherNet/IP Adapter Manual de usuario Pagina 27