Rockwell-automation 22-COMM-E EtherNet/IP Adapter Manual de usuario descargar pdf (Pagina 102)

9-10 Viewing the Adapter’s Web Pages

The Configure Process Display web page enables you to set a host’s

parameters whose values you want shown in the “Process status” fields

on the Home Page and the Process Display pop-up window. (When the

adapter is operated in Multi-Drive mode, the Home Page does not show a

“Process status” field for a host.) By default, this configuration is not

protected. After configuration, the settings can be protected by setting

the Parameter 30 - [Web Features] Proc Dsp Cfg Bit 1 value to “0”

(Disabled). To change a protected configuration, it must first be

unprotected by setting the Proc Dsp Cfg Bit 1 value back to “1”

(Enabled). For more information, see Chapter 3

, Setting Web Features

Access.

Figure 9.7 Example of Configure Process Display Web Page (Single Mode)

1. To set a host’s parameters whose values you want shown on Lines 1,

2, and 3 of the “Process status” fields in both the Home Page (only

Single mode) and Process Display pop-up window (Figure 9.3), type

the corresponding parameter number in each box.

Configure Process Display Web Page

Information Description

Line 1 – parameter # Number of the parameter whose value you want on Line 1.

Line 2 – parameter # Number of the parameter whose value you want on Line 2.

Line 3 – parameter # Number of the parameter whose value you want on Line 3.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 165 166

Sin comentarios

Rockwell-automation 22-COMM-E EtherNet/IP Adapter Manual de usuario Pagina 102