Rockwell-automation 22-COMM-E EtherNet/IP Adapter Manual de usuario descargar pdf (Pagina 41)

Configuring the Scanner or Bridge 4-5

The Module Properties dialog box (Figure 4.8) appears.

Figure 4.8 Module Properties Dialog Box - Page 1

3. Edit the following information about the adapter:

4. Under Connection Parameters, edit the following:

Type the number of bytes that are required for your I/O in the Input

Size and Output Size boxes. The size will depend on the I/O that you

enabled in the adapter. This information can be found in Parameter

22 - [DSI I/O Cfg] in the adapter. Table 4.A

shows common

configuration Input/Output sizes.

In our example, we typed 4 in the Input Size and Output Size boxes

because the Operating Mode Switch on the adapter is set to “Single”

(default) and Parameter 22 - [DSI I/O Cfg] is set to “Drive 0” (only

one drive being connected). Logic Command/Reference uses 2

Box Type

Name A name to identify the adapter and drive.

Comm. Format Data - INT.

This setting formats the data in 16-bit words.

IP Address The IP address of the adapter.

Box Assembly Instance Size

Input 1 (This value is

required.)

The value will vary based on your application

(setting of Parameter 22 - [DSI I/O Cfg]). It

will contain 2 additional words for ENBT

overhead. Refer to Table 4.A

on page 4-6.

Output 2 (This value is

required.)

The value will vary based on your application

(setting of Parameter 22 - [DSI I/O Cfg]).

Refer to Tabl e 4. A

on page 4-6.

Configuration 6 (This value is

required.)

0 (This value is required.)

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 165 166

Sin comentarios

Rockwell-automation 22-COMM-E EtherNet/IP Adapter Manual de usuario Pagina 41