Rockwell-automation 22-COMM-E EtherNet/IP Adapter Manual de usuario descargar pdf (Pagina 19)

Chapter 2

Installing the Adapter

Chapter 2 provides instructions for installing the adapter in a

PowerFlex 40 drive.

Before installing the EtherNet/IP adapter:

• Read the EtherNet/IP Performance and Application Guide,

Publication ENET-AP001…, and the EtherNet/IP Media Planning and

Installation Manual, Publication ENET-IN001….

• Verify that you have all required equipment. Refer to Chapter 1

Getting Started

Important: To guard against device malfunction, use a grounding wrist

strap when installing the EtherNet/IP adapter.

Before installing the adapter, you must set its Operating Mode Switch

for Single or Multi-Drive operation. To use the adapter web pages, the

Web Pages Switch must be set to its “Enable Web” position.

Important: New settings are recognized only when power is applied to

the adapter, or the adapter is reset. If you change a setting,

cycle power or reset the adapter.

Topic Page

Preparing for an Installation

2-1

Setting Operating Mode and Web Pages Switches 2-1

Connecting the Adapter to the Network 2-3

Connecting the Adapter to the Drive 2-4

Applying Power 2-6

Commissioning the Adapter 2-6

Preparing for an Installation

Setting Operating Mode and Web Pages Switches

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 165 166

Sin comentarios

Rockwell-automation 22-COMM-E EtherNet/IP Adapter Manual de usuario Pagina 19