Rockwell-automation 22-COMM-E EtherNet/IP Adapter Manual de usuario descargar pdf (Pagina 37)

Chapter 4

Configuring the Scanner or Bridge

Chapter 4 provides instructions on how to configure a ControlLogix

bridge to communicate with the adapter and connected PowerFlex drive.

After the adapter is configured, the connected drive and adapter will be a

single node on the network. This chapter provides the steps that are

needed to configure a simple network like the network in Figure 4.1

. In

our example, we will configure a 1756-ENBT bridge to communicate

with a drive using Logic Command/Status and Reference/Feedback over

the network.

Figure 4.1 Example EtherNet/IP Network

Topic Page Topic Page

Example Network

4-1 Adding the Adapter and Drive to the

I/O Configuration

4-4

Adding a Bridge or Scanner to the

I/O Configuration

4-2 Saving the Configuration 4-7

Example Network

PWR

STS

PORT

MOD

NET A

NET B

IP Address 131.200.130.176

ControlLogix Controller with

1756-ENBT Bridge

Computer with

Ethernet Connection

IP Address 131.200.130.178

PowerFlex 40 Drive with

EtherNet/IP Adapter

Switch

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 165 166

Sin comentarios

Rockwell-automation 22-COMM-E EtherNet/IP Adapter Manual de usuario Pagina 37