Rockwell-automation 1394 SERCOS Interface Multi-Axis Motion Control Sy Manual de usuario descargar pdf (Pagina 16)

Publication 1394-IN024B-EN-P — February 2004

1-8 Commissioning Your 1394 SERCOS Interface System

Configuring Your 1394 System Module

To configure your 1394 system module:

1. Verify that there is no 360/480V AC input power or 24V logic

power applied to the system and that the SERCOS fiber-optic

cables are connected to the Tx and Rx connectors. To verify your

fiber-optic cable connections, refer to the 1394 SERCOS Interface

Installation Manual (publication 1394-IN002x-EN-P).

2. Set the base node address for each 1394 controller in your system

by setting the Base Address switch. Refer to the example table

below for switch settings. Refer to figures 1.1 and 1.2 for switch

location. Configurations with up to nine 1394 SERCOS interface

system modules are possible.

Note: Base address 0 is used for troubleshooting and not a valid setting for normal operation.

For example, if the

number of 1394

SERCOS interface

system modules

you have is:

Set the Base Address switch

for system number:

1 to: 2 to: 3 to: 4 to: 5 to: 6 to: 7 to: 8 to: 9 to:

1 1 N/A N/A N/A N/A N/A N/A N/A N/A

2 1 2 N/A N/A N/A N/A N/A N/A N/A

3 1 2 3 N/A N/A N/A N/A N/A N/A

4 1 2 3 4 N/AN/AN/AN/AN/A

5 12345N/AN/AN/AN/A

6 123456N/AN/AN/A

7 1234567N/AN/A

8 12345678N/A

9 123456789

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 86 87

Sin comentarios

Rockwell-automation 1394 SERCOS Interface Multi-Axis Motion Control Sy Manual de usuario Pagina 16