Rockwell-automation 1503VC IntelliVAC Plus Contactor Control Module Manual de usuario descargar pdf (Pagina 145)

100

101

9-22 DeviceLogix

1503-UM054C-EN-P – June 2013

Figure 9.11 – Modify Function Block Attributes

In order to change a value:

1. Double-Click on the face of the function block you want to change.

2. Select Parameters tab

3. Locate the value that you want to change (values which can be

changed are white). Enter the new value in the box

4. Clic k OK. The new value takes immediate effect. If you are

changing a preset, remember to Save the configuration the next

time you exit from the Function Block Editor

Online Animation

Once you go online and the Logic Enable is set to ON, online

animation starts. The status of the I/O can be seen in the Function

Block Editor schematic. Note that in the online animation mode you

cannot edit instructions.

Change Logic

While the Function Block Editor is running and animated, you can

change the logic that appears on the schematic by first pressing the

Edit button or selecting Tools> Edit. When you change the logic,

the Function Block Editor will change from the animated mode into

Pending Edits mode. The logic in the device will not be affected and

the current program will continue to run. However, the screen will

not reflect the real-time status of the logic. The data on the wires

will be frozen to whatever it was when you modified the logic. To

ensure your changes take effect, perform the following steps:

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 386 387

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 1503VC IntelliVAC Plus Contactor Control Module Manual de usuario Pagina 145

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 1503VC IntelliVAC Plus Contactor Control Module