Rockwell-automation 2098-UWCPRG Ultraware Software User Manual Manual de usuario descargar pdf (Pagina 235)

Rockwell Automation Publication 2098-UM001G-EN-P - February 2011 237

Configuring the Kinetix 3 Drive Chapter 5

Understanding the Analog

Window

The Properties window for the Analog branch looks like this.

Use the Analog window to:

• set Analog Velocity, and Current Position Command Input drive

parameters for an online or offline drive,

• monitor the status of the incoming Analog Command for an online drive,

and

• execute commands that remove Velocity, and Current Input Offsets for an

online drive.

These parameters govern drive operations when the Operating Mode is set to

Analog Velocity Input or Analog Current Input.

Parameter Description

Velocity Command Input:

Velocity Scale The drive's velocity input scale value. This value indicates the

change in velocity per Volt of change in the Analog Command

Input.

The range is 0…1000 rpm (millimeters per second for linear

motors). The default is 100.

Current Scale The drive's current input scale value. This value indicates the

change in current per Volt of change in the Analog Command

Input.

Note: This parameter is stored on the drive in units of percent of

motor rated continuous current/Volt.

The range, as a percentage, is 0 …100%/V. The default setting

is 33.3%/V.

Velocity Command Offset The offset of the Analog Velocity Command Input in millivolts.

The range is -1000 …1000 mV

Current Command Offset The offset of the Analog Command Input in mV.

The range is -1000 to 1000 miV.

Position Command Input:

Position Scale The drive's position input scale value. This value indicates the

change in position per Volt of change in the Analog Command

Input. The range is -32767…32767 counts/V.

Position Offset The drive's position input offset value. This value indicates the

offset of the Analog Command Input. The range is

-10000…1000 mV.

1 2 ... 230 231 232 233 234 235 236 237 238 239 240 ... 353 354

Sin comentarios

Rockwell-automation 2098-UWCPRG Ultraware Software User Manual Manual de usuario Pagina 235