Rockwell-automation 294E ArmorStart LT EtherNet/IP Version - User Manu Manual de usuario descargar pdf (Pagina 221)

Rockwell Automation Publication 290E-UM001B-EN-P - June 2012 221

CIP Information Appendix B

5 Phase U to Gnd A Phase U to Ground fault detected between drive and motor. 38

6 Phase V to Gnd A Phase V to Ground fault detected between drive and motor. 39

7 Phase W to Gnd A Phase W to Ground fault detected between drive and motor. 40

8 Phase UV Short Excessive current detected between phases U and V. 41

9 Phase UW Short Excessive current detected between phases U and W. 42

10 Phase VW Short Excessive current detected between phases V and W. 43

11 Ground Fault A current path to earth ground at one or more output terminals. 13

12 Stall Trip The drive is unable to accelerate the motor. 6

13 Switched Power Indicates the loss of switched control power.

Not available in units with Integrated Power Supply

14 Under Power Trip Indicates the internal power supply is below its working level.

Available in units with Integrated Power Supply only.

15 Sensor Short Flags a miswired hardware input point.

16 Output Short Flags a miswired hardware output point.

17 Fault 17

18 Heatsink Temp The Heatsink temperature exceeds a predefined value. 8

19 HW Over Current The drive output current has exceeded the hardware limit. 12

20 SW OverCurrent Programmed parameter 83 (SW Current Trip) has been exceeded. 63

21 Aux Power Loss Auxiliary Power was lost or dipped below the minimum threshold.

Not available in units with Integrated Power Supply.

22 Internal Comm Communication with the internal Power Flex drive has been lost. 71

23 Drive Comm Loss The RS485 port on the internal Power Flex stopped communicating. 81

24 Power Loss Drive DC Bus Voltage remained below 85% of nominal bus voltage. 3

25 Under Voltage DC Bus Voltage fell below the minimum value. 4

26 Over Voltage DC Bus Voltage exceeded the maximum value. 5

27 MCB EEPROM This is a major fault which renders the ArmorStart inoperable.

28 Param Sync The drive and Main Control Board EEPROMS are not in sync.

29 Drive EEPROM The drive EEPROM checksum checks have failed. 100

30 Hardware Fault This is a major fault which renders the unit inoperable

31 Fan RMP The internal cooling fan is not running properly.

32 Power Unit A major failure has been detected in the drive power section. 70

33 Drive I/O Brd A failure has been detected in the drive control and I/O section. 122

34 Restart Retries Automatic fault reset and run retries exceeded. 33

35 Drive Aux In Flt The drive auxiliary input interlock is open inside the ArmorStart. 2

36 Fault 36 —

37 Drv Param Reset Internal Drive Parameters (Parameters > 100) have been defaulted. 48

38 Fault 38 —

39 Fault 39 —

40 Unknown Fault —

Table 34 - Fault Codes, Fault Text, and Fault Help Strings for Drive Units

Fault

Code Fault Text Help Text

PF4M

Fault

Code

1 2 ... 216 217 218 219 220 221 222 223 224 225 226 ... 251 252

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 294E ArmorStart LT EtherNet/IP Version - User Manu Manual de usuario Pagina 221

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 294E ArmorStart LT EtherNet/IP Version - User Manu