Rockwell-automation 294E ArmorStart LT EtherNet/IP Version - User Manu Manual de usuario descargar pdf (Pagina 231)

Rockwell Automation Publication 290E-UM001B-EN-P - June 2012 231

Using DeviceLogix™ Appendix C

2. Click on the “DeviceLogix” tab. If you are on-line with a device, a dialog

box will appear asking you to upload or download. Click on “Upload.”

3. Click the “Start Logic Editor” button.

4. If programming off-line continue to step 5, otherwise click on the “Edit”

button. Click “Ye s” when asked if you want to Enter Edit Mode. Once in

edit mode the entire list of Function Blocks will be displayed in the

toolbar.

5. Left Click on the “RSL” function block. This is a reset dominate latch.

6. Move the cursor into the grid, and left click to drop the function onto the

grid.

7. From the toolbar, Click on the “Discrete Input” button and select Pt00

from the pull-down menu. This is the remote start button based on the

example I/O table.

8. Place the input to the left of the RSL function. To drop the input on the

page, left click on the desired position.

9. Place the mouse cursor over the tip of Pt00. The tip will turn green. Click

on the tip when it turns green.

10. Move the mouse cursor toward the input of the RSL function. A line will

follow the cursor. When a connection can be made, the tip of the RSL

function will also turn green. Click the on Input and the line will be drawn

from Pt00 to the Set Input of the RSL function.

Note: If this was not a valid connection, one of the pin tips would have turned

red rather than green. Left double clicking on the unused portion of the grid or

pressing the “Esc” key at any time will cancel the connection process.

1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 251 252

Sin comentarios

Rockwell-automation 294E ArmorStart LT EtherNet/IP Version - User Manu Manual de usuario Pagina 231