Rockwell-automation MPMA Integrated Multi-Axis Linear Stages Manual de usuario Pagina 72
- Pagina / 136
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
72 Rockwell Automation Publication MPMA-UM001B-EN-P - November 2010
Chapter 8 Removing and Replacing Multi-axis Stage Components
13. Adjust the seal guide by inserting a 0.8 mm (0.030 in.) shim between the
seal guide and the strip seal.
14. Return the linear stage to service.
Install the Side Cover
Follow these directions to install a side cover.
1. Insert a side cover into the base of the linear stage by holding it with the
top slightly tilted outward and hooking the bottom of the side cover in the
channel near the bottom of the base.
2. Starting at the end cap adjacent to the ground screw, install one M4 SHCS
and torque it to 4 N•m (35 lb•in).
3. On the opposite end install one M3 SHCS and torque it to 2.5 N•m
(20 lb•in).
Seal Guide
0.8 mm (0.03 in.) Shim
Strip Seal
TIP
If installing the side cover with strip seals in place use a flat-blade
screwdriver to lift the side cover by inserting the screwdriver under
the cover between the cover and the base.
- User Manual 1
- Important User Information 2
- Table of Contents 3
- About This Publication 7
- Who Should Use This 7
- Additional Resources 7
- Multi-axis Stage Safety 9
- Safety Labels 10
- LIFT HAZARD 11
- Two Person Lift 11
- PINCH POINTS 11
- ºC (167 ºF) 12
- Standards 13
- Motor Model Identification 13
- MPMA - xxxxxxxxx - xx 16
- Identifying the Components 17
- (MPMA-xBxxxxxx-SxC shown) 18
- (MPMA- xCxxxxxxx-SxC shown) 19
- Identifying the Individual 20
- Linear Stages in Your 20
- Multi-axis Stage 20
- Component Descriptions 23
- Maintenance Intervals 24
- Mounting Restrictions 27
- (MPMA-xA/Cxxxxxx-SxC) 28
- Clearance Requirements 29
- Unpacking, Handling, and 31
- Inspection 31
- Unpacking Guidelines 32
- Unpack the Multi-axis Stage 33
- Multi-axis Stage Storage 35
- Mount the Multi-axis Stage 35
- Mount Your Application 36
- Connect the Multi-axis 37
- About the Air Option for 40
- Ball Screw Linear Stages 40
- About the Brake Option for 40
- Meeting UL Installation 41
- Linear Stage Connector Data 43
- ALMx2X) 44
- Configuration Guidelines 47
- Configure Your Linear Stage 48
- Configure RSLogix 5000 49
- Software for Linear Stages 49
- 5 mm, min 0.2 in., min 50
- Ball Screw Drive Stages 51
- Tune Your Linear Stage 53
- IMPORTANT 54
- Loop Bandwidth and click OK 57
- Configure Ultraware 58
- Units (mm or in.) 59
- Set Travel Limits 60
- Program Home to Torque for 60
- Kinetix Multi-axis Drives 60
- Maintenance 61
- Lubricate the Bearing 62
- Clean the Strip Seal 63
- Clean the Cover 63
- Chapter 7 Maintenance 64
- Components 65
- Before You Begin 66
- Cable Carrier Assembly 66
- Removal Procedures 66
- Multi-axis Stages 67
- Installation 69
- Remove the Strip Seal 69
- Remove the Cover 70
- Install the Cover 70
- Replace the Strip Seal 71
- Install the Side Cover 72
- Replace the Rotary Motor 73
- Troubleshooting 75
- Troubleshooting During 76
- Commission and Startup 76
- Operational 76
- and page 79 78
- MPMA-xABxxxxxx-xxx 82
- Product Specifications and 82
- Dimensions 82
- MPMA-xACxxxxxx-xxx 84
- MPMA-xAPxxxxxx-xxx 86
- MPMA-xCBxxxxxx-xxx 89
- MPMA-xCQxxxxxx-xxx 92
- MPMA-xBExxxxxx-xxx 94
- MPMA-xBIxxxxxx-xxx 96
- MPMA-xBDxxxxxx-xxx 98
- Accessories 103
- Accessories Appendix B 105
- Installation, Maintenance 106
- Interconnect Diagrams 111
- 2000 Drives 112
- 6000 Drives 113
- Home to Torque-level Example 115
- About Home to Torque-level 116
- Drive Bipolar Torque Limit 118
- Adjustment 118
- Disable Soft Overtravel 119
- Ladder Code Example 119
- Potential for Position Error 126
- Appendix 127
- Introduction 127
- Rockwell Automation Support 136
- Documentation Feedback 136
Relacionado con productos y manuales para Equipo Rockwell-automation MPMA Integrated Multi-Axis Linear Stages
Equipo Rockwell-automation T80020 Application Note Diagnostic Procedures Manual de usuario
(71 paginas)
(71 paginas)
Equipo Rockwell-automation 1440-TB-C XM-942 Master Relay Terminal Base Manual de usuario
(20 paginas)
(20 paginas)
Equipo Rockwell-automation GV3000/SE 230VAC 1-20 HP GP & Vector Drive Ver Manual de usuario
(224 paginas)
(224 paginas)
Equipo Rockwell-automation T8403 Trusted TMR 24V dc Digital Input Module Manual de usuario
(2 paginas)
(2 paginas)
Equipo Rockwell-automation System Release 3.0 PlantPAx System Application Tem Manual de usuario
(80 paginas)
(80 paginas)
Equipo Rockwell-automation Logix5000 Control Systems: Connect POINT I/O Modul Manual de usuario
(36 paginas)
(36 paginas)
Equipo Rockwell-automation Liqui-Flo DBT Reach Drive Recommended Lifting Inst Manual de usuario
(4 paginas)
(4 paginas)
Equipo Rockwell-automation CEP7- Sprecher+Schuh CEP7 E3 Electronic Overload R Manual de usuario
(2 paginas)
(2 paginas)
Equipo Rockwell-automation T8844 Trusted 40 Channel Analogue Input Versatile Manual de usuario
(14 paginas)
(14 paginas)
Equipo Rockwell-automation 20B PowerFlex 70 / 700 Parameters FRN 3.xx Manual de usuario
(43 paginas)
(43 paginas)
Equipo Rockwell-automation 1440-TBS-J XM Dynamic Measurement Module Terminal Manual de usuario
(24 paginas)
(24 paginas)
Equipo Rockwell-automation TD200 AC Drive V1.0, 0.3-20V RMS, 3-Ph, 63A Manual de usuario
(32 paginas)
(32 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.101 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales