Rockwell-automation 284E ArmorStart with EtherNet/IP - User Manual Manual de usuario descargar pdf (Pagina 300)

300 Rockwell Automation Publication 280E-UM001B-EN-P – July 2012

Appendix B CIP Information

The table below lists Fault Codes, Fault Text, and Fault Help Strings for VFD

units.

36 Fault 36 —

37 Fault 37 —

38 Fault 38 —

39 Fault 39 —

40 Unknown Fault —

41 Fault 41 —

42 Fault 42 —

43 Fault 43 —

44 Fault 44 —

45 Fault 45 —

Table 50 Bulletin 284E

Fault Code Fault Text Help Text

1 Hdw Short Ckt The built in 140M Circuit Breaker has tripped.

2Fault 2 —

3 Motor Overload The Load has drawn excessive current.

4 Drive Overload 150% load for 1 min. or 200% load for 3 sec. exceeded

5 Phase U to Gnd A Phase U to Ground fault detected between drive and motor.

6 Phase V to Gnd A Phase V to Ground fault detected between drive and motor.

7 Phase W to Gnd A Phase W to Ground fault detected between drive and motor.

8 Phase UV Short Excessive current detected between phases U and V.

9 Phase UW Short Excessive current detected between phases U and W.

10 Phase VW Short Excessive current detected between phases V and W.

11 Ground Fault A current path to earth ground at one or more output terminals.

12 Stall The drive is unable to accelerate the motor.

13 Control Pwr Loss Indicates the loss of control power. This fault can be disabled.

14 Control Pwr Fuse The Control Power Fuse has blown. Remove power and replace fuse.

15 Input Short Flags a shorted sensor, input device, or input wiring mistake.

16 Output Fuse The Output Fuse has blown. Remove all power and replace the fuse.

17 Over Temp Indicates the operating temperature has been exceeded.

18 Heatsink OvrTmp The Heatsink temperature exceeds a predefined value.

19 HW OverCurrent The drive output current has exceeded the hardware limit.

20 SW OverCurrent Programmed parameter 198 (SW Current Trip) has been exceeded.

21 A3 Power Loss Unswitched (A3) Power was lost or dipped below the 12V DC threshold.

22 Internal Comm Communication with the internal Power Flex drive has been lost.

23 Drive Comm Loss The RS485 port on the internal Power Flex stopped communicating.

Table 49 - Bulletin 280E/281E

Fault Code Fault Text Help Text

1 2 ... 295 296 297 298 299 300 301 302 303 304 305 ... 347 348

Sin comentarios

Rockwell-automation 284E ArmorStart with EtherNet/IP - User Manual Manual de usuario Pagina 300