Rockwell-automation 1305 AC Drive, Firmware 1.01-3.00 User Manual Manual de usuario descargar pdf (Pagina 66)

Chapter 4 –Start–Up

4-8

ATTENTION: Proceed with caution. A DC Bus Voltage may be present at the Power Terminal Block (TB1) even

when power is removed from the drive.

❏ 16. Reconnect the Motor.

Remove ALL Power

Reconnect Motor

a.) Disconnect and lock-out all input and control power to the drive. When

the HIM Display is no longer illuminated, remove the drive cover.

b.) Verify that the DC Bus neon indicator is not illuminated (Refer to

Figure 2.3 for location). Reconnect the motor leads to the drive and

replace the drive cover.

IMPORTANT:The parameters in the Set Up Group (page 5-8) should be

reviewed and reprogrammed as necessary for basic operation.

ATTENTION: In the following steps, rotation of the motor in an un-desired direction can occur. To guard against

possible equipment damage, it is recommended that the motor be disconnected from the load before proceeding.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 161 162

Sin comentarios

Rockwell-automation 1305 AC Drive, Firmware 1.01-3.00 User Manual Manual de usuario Pagina 66