Rockwell-automation 21G PowerFlex 750-Series AC Drives Programming Man Manual de usuario descargar pdf (Pagina 310)

310 Rockwell Automation Publication 750-PM001J-EN-P - October 2014

Chapter 6 Troubleshooting

Power Layer Interface (PLI)

Board 7-Segment Display

PowerFlex 755 Frame 8 and larger drives utilize a pair of 7-segment displays to

indicate drive status and conditions.

Series A Display

Series B Display

Lit Segment Indication Description

Fault Clear Indicates a fault condition has been cleared.

Fault Indicates a fault condition exists.

Power On Indicates that power is applied to the PLI board.

Charged Indicates the state of the pre-charge pin.

PWM Enable IGBT gating is enabled. When disabled, all IGBT signal inputs to the PLI IGBT

driver chip are low. IGBT gating is enabled by setting bit 0 of the Config Register.

IGBT gating is disabled by clearing bit 0 or by “POE” fault (IOC, Bus Overvoltage,

or Ground Fault).

Fiber Loss Fault Turns on when a Fiber Loss fault occurs. A Fiber Loss fault occurs when the LOS

signal is high or when a valid data packet has not been received for a period of

1024 μs. The fault is latched and is cleared be setting bit 8 of the Config Register.

The Fiber Loss fault inhibits IGBT firing in the same manner as a “POE” fault.

Fiber Loss Pin Indicates the actual state of the LOS pin described in Write Enable.

SAFE Vcc Power On Power is applied to the PLI IGBT driver chip (U14). Delayed for 12 seconds after

power up.

Write Enable Data writes from the Fiber Optic link are enabled to PLI registers. Data writes are

disabled for ten seconds (time required for the Control Board to initialize) after

negation of the LOS pin of the PLI fiber optic transceiver. LOS is driven high when

the optical power into the fiber optic receiver is too low (broken, crimped,

disconnected fiber, or transmitter at opposite end of fiber is not operating.

Lit Segment Indication Description

PWM Enable IGBT gating is enabled. IGBT gating is enabled by setting bit 0 of the Config

Fault Indicates a fault condition exists.

Initialization Done Indicates that the control has initialized the PLI board.

Fiber Loss Actual state of the LOS pin. LOS is driven high when the optical power into the

fiber optic receiver is too low (broken, crimped, disconnected fiber, or

transmitter at opposite end of fiber is not operating.

On Line The PLI is powered.

System Safety

Enable B

Pin 1 of the 541 PLI IGBT driver chip (U14) is low. This pin must be low to fire the

IGBTs.

Aux Power The PLI board is powered by a 24 volt auxiliary supply.

1 2 ... 305 306 307 308 309 310 311 312 313 314 315 ... 543 544

Sin comentarios

Rockwell-automation 21G PowerFlex 750-Series AC Drives Programming Man Manual de usuario Pagina 310