Rockwell-automation 21G PowerFlex 750-Series AC Drives Programming Man Manual de usuario descargar pdf (Pagina 352)

352 Rockwell Automation Publication 750-PM001J-EN-P - October 2014

Chapter 6 Troubleshooting

xx072 Ch0 ROM Error Configurable P9

[FB0 Loss Cfg]

Error reported by a linear Stahl encoder on Channel 0 - Indicates a ROM

error. Reading head needs to be repaired

xx074 Ch0 No Position Configurable P9

[FB0 Loss Cfg]

Error reported by a linear Stahl encoder on Channel 0 - Indicates that no

position value was available - only possible following powerup or reset

xx081 Ch0 Msg Cheksum Configurable P9

[FB0 Loss Cfg]

Indicates the option card has detected a serial communications

checksum error while attempting to communicate with the encoder on

channel 0.

xx082 Ch0 Timeout Configurable P9

[FB0 Loss Cfg]

Indicates the option card has detected a serial communications timeout

error while attempting to communicate with the encoder on channel 0.

xx083 Ch0 Comm Configurable P9

[FB0 Loss Cfg]

Indicates the option card has detected a serial communications error

(other than checksum or timeout) while attempting to communicate

with the encoder on channel 0.

xx084 Ch0 Diagnostic Configurable P9

[FB0 Loss Cfg]

Indicates the option card has detected a powerup diagnostic test failure

for encoder channel 0.

xx085 Ch0 SpplyVltgRng Configurable P9

[FB0 Loss Cfg]

Indicates that the voltage source to the encoder 0 is out of range.

xx086 Ch0 SC Amplitude Configurable P9

[FB0 Loss Cfg]

Indicates that the encoder 0 signal amplitude is out of tolerance.

xx087 Ch0 Open Wire Configurable P9

[FB0 Loss Cfg]

Indicates that an open wire condition has been detected for encoder 0.

Both Sine and Cosine signals fell below 0.3 volts.

xx088 Ch0 Quad Loss Configurable P9

[FB0 Loss Cfg]

Indicates that a signal quadrature error has been detected for encoder 0.

Add ferite cores.

xx089 Ch0 Phase Loss Configurable P9

[FB0 Loss Cfg]

Indicates that an A or B signal of an A quad B incremental encoder on

Channel 0 is disconnected.

xx090 Ch0 Unsupp Enc Configurable P9

[FB0 Loss Cfg]

Indicates that the connected encoder on Channel 0 is not supported

xx100 Ch0 FreqExc Alm Alarm 1 P9

[FB0 Loss Cfg]