
Troubleshooting the Module and Network
8-11
21 Flt Cfg Error Flt Cfg for the Reference or Datalinks is set to
a value greater than 65535 and the host
requires a 16-bit value.
22 App Updated New application firmware detected.
23 EN Comm Flt The module detected a communications fault
on the network.
24 EN Sent Reset The module received a fault from the network.
25 EN Close Fit An I/O connection from the network to the
module was closed.
26 EN Idle Flt The module is receiving “idle” packets from the
network.
27 EN Open An I/O connection from the network to the
module has been opened.
28 EN Timeout Flt An I/O connection from the network to the
module has timed out.
29 PCCC IO Close The device sending PCCC Control messages
to the module has sent the PCCC Control
Timeout to a value of zero.
30 PCCC IO Open The module has begun receiving PCCC
Control messages.
31 PCCC IO Time Flt The module has not received a PCCC Control
Message for longer than the PCCC Control
Timeout.
32 Watchdog T/O Flt The software detects a failure.
33 EEPROM Init A blank EEPROM map revision detected.
34 Normal Startup The module completes a normal start up.
35 Manual Reset The module was reset by changing parameter
20 (Reset Module).
36 EN Link Down The Ethernet link was removed from the
module.
37 EN Link Up An Ethernet link is available for the module.
38 BOOTP Response The module received a response to its BOOTP
request.
39 Dup IP Addr The module uses the same IP address as
another device on the network.
40 Peer IO Open The module received the first Peer I/O image.
41 Peer IO Time Flt The module has not received a Peer I/O
message for longer than the Peer I/O Timeout.
42 Email Failed The module encountered an error attempting
to send a requested e-mail message.
Table 8.7 – Event Codes and Descriptions
Code Event Description
Comentarios a estos manuales