Rockwell-automation RECOMM-ENET EtherNet/IP Communications Module Manual de usuario Pagina 17

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 194
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 16
Getting Started
2-1
CHAPTER 2
Getting Started
This chapter provides:
A description of the EtherNet/IP modules components
A list of parts shipped with the module
A list of user-supplied parts required for installing the module
An installation checklist
Status Indicators Four LEDs to indicate the status of the connected
drive, module, and network. Refer to chapter 6 for
more information about the LEDs.
DPI Connector A 20-pin, single-row shrouded male header. An
Internal Interface cable connects to this connector
and one on the drive.
Ethernet
Connector
An RJ-45 connector the Ethernet cable. The
connector is CAT-5 compliant to ensure reliable
data transfer on 100Base-TX Ethernet
connections.
Web Page
Switch (SW2)
Enables or disables the module web pages. Refer
to Chapter 3, Setting the Web Pages Switch
(Firmware 3.xxx only). SW1 is unused.
Figure 2.1 – Components of the EtherNet/IP Module
Not provided on
firmware version 2.xxx
or earlier
Vista de pagina 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 193 194

Comentarios a estos manuales

Sin comentarios