Rockwell-automation RECOMM-ENET EtherNet/IP Communications Module Manual de usuario Pagina 49

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 194
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 48
Configuring the Scanner or Bridge
5-1
CHAPTER 5
Configuring the
Scanner or Bridge
Chapter 5 provides instructions on how to configure a ControlLogix
bridge to communicate with the module and connected drive.
5.1 Configuring a Simple Network: An
Example
After the module is configured, the connected drive and module will
be a single node on the network. This chapter provides the steps
that are needed to configure a simple network like the network in
figure 5.1.
In our example, we will configure a 1756-ENBT (series A) bridge to
communicate with a drive using Logic Command/Status, Reference/
Feedback, and four 16-bit datalinks over the network.
Figure 5.1 – Sample EtherNet/IP Network
PWR
STS
IP Address 131.200.130.176
ControlLogix Controller with
1756-ENBT Bridge
IP Address 131.200.130.178
SP600 Drive with
EtherNet/IP Module
Computer with Ethernet Connection
Ethernet
Switch
Vista de pagina 48
1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 193 194

Comentarios a estos manuales

Sin comentarios