
Installing the EtherNet/IP Module
3-5
3.4 Connecting the Module to the
Network
Step 1. Remove power from the drive.
Step 2. Use static control precautions.
Step 3. Connect an Ethernet cable to the EtherNet/IP network.
Refer to figure 3.4.
Step 4. Route the Ethernet cable through the bottom of the
drive and connect it to the module.
Step 5. Connect the cable to the module (refer to figure 3.2).
!
ATTENTION: The Reliance Electric drive may
contain high voltages that can cause injury or death.
Remove power from the drive, and then verify power
has been discharged before installing or removing
a module. Failure to observe this precaution could
result in severe bodily injury or loss of life.
Figure 3.4 – Connecting the Ethernet Cable to the Network
Router
(Optional)
ControlLogix with
EtherNet/IP Bridge
SP600
Drive
GV6000
Drive
with
RECOMM-ENET
with
RECOMM-ENET
Comentarios a estos manuales