Rockwell-automation RECOMM-ENET EtherNet/IP Communications Module Manual de usuario descargar pdf (Pagina 112)

Viewing the Module’s Web Pages

9-10

Important:For firmware 2.xxx (and earlier) modules, it is

recommended that Access Control (54) E-mail Config

Bit 1 value be set to “0” (Disabled) after E-mail

Notification has been configured. Otherwise the

configuration can be changed anytime the web page is

accessed with a browser.Forfirmware 3.xxx (and later)

modules, it is recommended that Web Features (56) E-

mail Cfg Bit 0 value be set to “0” (Disabled) after E-mail

Notification has been configured. Otherwise the

configuration can be changed anytime the web page is

accessed with a browser.

An example of an e-mail message automatically sent by the adapter

in response to selected events is shown below.

Note: To stop e-mail messages, do one of the following:

• Delete all e-mail addresses from the Configure E-mail Notification

web page.

• Uncheck all of the “Send an e-mail message when ...” boxes.

For firmware 2.xxx (and earlier) modules, disabling the adapter web

pages by using Access Control (54) to set the Web Enable Bit 0

value to “0” (Disabled) will NOT stop the module from sending e-

mail messages.

For firmware 3.xxx (and later) modules, setting the Web Pages

Switch to the “Disable Web” position will NOT stop the module from

sending e-mail messages.

Figure 9.6 – Example of E-mail Message Ssent by Module

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 193 194

Sin comentarios

Rockwell-automation RECOMM-ENET EtherNet/IP Communications Module Manual de usuario Pagina 112