
B-16
EtherNet/IP Communications Module
This parameter is only available for firmware version 2.xxx (and
earlier) modules. Sets the access to the Web interface and
Web-configurable features such as e-mail notification.
This parameter is only available for firmware version 3.xxx (and
later) modules.
Displays the setting of the Web Pages Switch (SW2) on the module
when the module was last reset.
54 Access Control
Range: 0 = Disabled
1 = Enabled
Default: xxxx xx01
Type: Read/Write
Reset Required: No
Figure 2.5 – Access Control
55 Web Enable
Range: 0 = Disabled
1 = Enabled
Default: 0 = Disabled
Type: Read Only
1xxxxxx
01234576
1
x
31
Bit
Default
0 = Web Enable
1 = E-mail Config
2 -31 = Not Used
56 Web Features
Range: 0 = Disabled
1 = Enabled
Default: xxxx xxx1
Type: Read/Write
Reset Required: No
Comentarios a estos manuales