Rockwell-automation RECOMM-ENET EtherNet/IP Communications Module Manual de usuario descargar pdf (Pagina 94)

8-4

EtherNet/IP Communications Module

8.1.3 NET A Status Indicator

Table 8.4 – NET A Status Indicator: State Definitions

Status Cause Corrective Action

Off The module and/or

network is not

powered, the

module is not

connected properly

to the network, or

the module needs

an IP address.

• Securely connect the module to

the drive using the Internal

Interface cable and to the

network using an Ethernet

cable.

• Correctly connect the Ethernet

cable to the Ethernet connector.

• Set a unique IP address using a

BOOTP server or disabling

BOOTP and using parameters.

• Apply power to the drive and

network.

Solid Red The module failed

duplicated IP

address detection

test.

• Configure the module to use a

unique IP address and cycle

power.

Flashing

Red

An EtherNet/IP

connection has

timed out.

• Place the scanner in RUN

mode, or apply power to the

peer device that will send I/O.

• Check the amount of traffic on

the network.

Flashing

Red/

Green

The module is

performing a self

test.

• No action is required.

Flashing

Green

The module is

properly connected

but is not

communicating

with any devices

on the network.

• Place the controller in RUN, or

apply power to the peer device

that will send I/O.

• Program a controller or peer

device to recognize and

transmit I/O or make a

messaging connection to the

module.

• Configure the module for the

program in the controller or the

I/O from the peer device.

Solid

Green

The module is

properly connected

and

communicating

with the network.

• No action required.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 193 194

Comentarios a estos manuales

Sin comentarios

Rockwell-automation RECOMM-ENET EtherNet/IP Communications Module Manual de usuario Pagina 94

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation RECOMM-ENET EtherNet/IP Communications Module