
B-2
EtherNet/IP Communications Module
Display the port number to which the module is connected. This will
usually be port 5.
Displays the data rate used by the drive. This data rate is set in the
drive and the module detects it.
Configures the module to use BOOTP so that you can set its IP
address, subnet mask, and gateway address with a BOOTP server.
1DPI Port
Range: 0 to 7
Default: 5
Type: Read Only
Reset Required: N/A
2 DPI Data Rate
Range: 0 = 125 Kbps
1 = 500 Kbps
Default: 0 = 125 Kbps
Type: Read Only
Reset Required: N/A
3BOOTP
Range: 0 = Disabled
1 = Enabled
Default: 1 = Enabled
Type: Read/Write
Reset Required: Ye s
Comentarios a estos manuales