Rockwell-automation 592- E300 Overload Relay User Manual Manual de usuario descargar pdf (Pagina 120)

120 Rockwell Automation Publication 193-UM015B-EN-P - June 2014

Chapter 5 Protective Trip and Warning Functions

• Any relay outputs configured as a Warning Alarm will close

L1 Over Current Warning Level

L1 Over Current Warning Level (Parameter 278) allows the user to define the

current at which the E300 Electronic Overload Relay will indicate a L1 Over

Current warning. It is user-adjustable from 10…100% for the FLA Setting

(Parameter 171).

Table 106 - L1 Over Current Warning Level (Parameter 278)

L2 Over Current Trip

The E300 Electronic Overload Relay will trip with a L2 Over Current indication

if:

• No trip currently exists

• 2 Over Current Trip is enabled

• Current is present

• Over Current Inhibit Timer has expired

• 2 Percent FLA (Parameter 48) is greater than the L2 Over Current Trip

vel for a time period greater than the L2 Over Current Trip Delay.

If the E300 Electronic Overload Relay trips on a L2 Over Current, the:

• T

RIP/WARN LED status indicator will flash a red 12-short blink pattern

• Bit 11 in Current Trip Status (Parameter 4) will set to 1

• Bit 0 in Device Status 0 (Parameter 20) will set to 1

• Any relay outputs configured as a Trip Relay will open

• Any relay outputs configured as a Control Relay will open

• Any relay outputs configured as a Trip Alarm will close

• Any relay outputs configured as a Normal Relay will be placed in their

otection Fault state (if so programmed)

Default Value 90

Minimum Value 10

Maximum Value 100

Parameter Type USINT

Size (Bytes) 1

Scaling Factor 1

Units %FLA

IMPORTANT

The L1 Over Current Warning function does not include a time delay feature.

Once the Over Current Inhibit Timer has expired, the L1 Over Current Warning

indication is instantaneous.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 423 424

Sin comentarios

Rockwell-automation 592- E300 Overload Relay User Manual Manual de usuario Pagina 120