Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Manual de usuario descargar pdf (Pagina 134)

100

101

Editing ProgramsOn Line

Chapter 5

5-14

3. Key in an initial sequence number (the number for the first sequence

number), a comma, and an incremental value for the control to add to

each new sequence number. The format to this command is

RENUM: initial-sequence-number, incremental -value

For example

RENUM:5,10

would make the first sequence number 5, the next 15, 25, 35....

Important: You must enter both the initial sequence number and the

incremental value as integer values. If you use a decimal point, the control

issues the error message “ILLEGAL VALUE”.

If no initial sequence number or no incremental value is given or

both are not entered, the control uses default values of one.

4. Select the blocks to renumber by using one of the two choices:

(softkey level 4)

ALL ONLY

Ifyo u want to: Then press:

assignsequence numbersor toreassignsequence numbersto

all blocksfromthe beginning ofthepart program

{ALL} softkey

assignnew sequence numbersto only theblocksthatalready

havesequencenumbers

{ONLY N}

softkey

ATTENTION: When the control performs a renumber

operation, features in the part program that reference a specific

block number may no longer be referencing the correct block.

For example, a paramacro GOTO 10 command may not call t he

correct block after the renumber operation. When a renumber

operations is performed, you must manually go through the

program to make sure that these block references are correct.

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 819 820

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Manual de usuario Pagina 134

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra